VTech VT 1921 manual Operating instructions. Adjust, Damaged, Vtech Communications, Cycles Charge

Page 7

12.Unplug this product from the wall outlet and refer servicing to a VTech authorized service facility under the following conditions:

A.When the power supply cord or plug is damaged or frayed.

B.If liquid has been spilled into the product.

C.If the product has been exposed to rain or water.

D.If the product does not operate normally by following the

operating instructions. Adjust

onlythosecontrolsthatarecovered

by the operating instructions, because improper adjustment of other controls may result in damage and will often require extensive work by a VTech authorized technician to restore the product to normal operation.

E.If the product has beendropped and the cabinet has been

. . damaged.

F.If the product exhibits a distinct change in performance.

---

-L-.;;_..;.. i....-r * ,,

. .

 

I

Y,;INSTRUCTIONS

i

. . . . .

. ,. . .

I

. . . . . . . . . . . . . . . . . . . . . . .

 

13.Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lighting.

14.Do not use the telephone to report a gas leak in the vicinity of the leak.

VTECH COMMUNICATIONS

SERVICE DEPT. at 1-800-595-9511

in the US . and 1-800-267-7377

In Canada.

CHARGING THE ,HANDSET ,BAT- TERY PACK

The handset of your VT 1921 cordless telephone is powered by a rechargeable battery pack. It charges automatically whenever the handset is in the base. You should charge the battery pack for 16 hours when you first receive your phone. Yo)JIII know the battery pack needs charging when:

The phone epits a warning tone when you press the PHONE key.

The low battery message is displayed:

I

!The handsel seems completd dead, the LCD is clear and the handset does not beep when you press the keys.

To Charge The. Battery Pack

To charge the battery pack, place the handset in the, base unit. The CHARGE indicator will light to show the handset is seated properly and

the battery is charging. It is

Alternatively, if you have purchased a spare battery pack and it has been charging in the base unit, simply exchange the drained handset battery pack with the fully charged replace- ment battery pack from the base charger. Place the drained handset battery pack into the base charger to recharge.

The base spare battery charger does NOT charge a battery pack as quickly as the handset battery charger. A full charge requires 24 hours when using the spare battery charger.

IT'S IMPOSSIBLE TO OVER CHARGE THE BATTERY PACK

The battery pack can be rechargedmany times, but if you get a low-battery signal even after 16 hours of charging in the base cradle (or 24 hours in the base spare batterycharger),thebatterypack(s) should be replaced.

To purchase replacement battery packs, call VTech Communications at 1-800-595-9511inthe U.S. and VTech Electronics Canada Ltd at 1-800-

A WORD ABOUT RECHARGEABLE BATTERIES

SAVE THESE INSTRUCTIONS

recommended tTat the battery pack be charged for at least 16 hours initially and 8 h urs for maintenance charging. You c3n use your telephone before that with diminished capacity,

capacity of youimizebattery pack. The maximumbatte life between charges is 7 hours of co tinuous talk time or 7 days of stand by.

but it is best to c arge the battery pack

fully. It

will

ta

several

recharge

cycles

to

ma

the

charge

Your Nicad battery pack recharges whenever the Handset is returned to the Base Unit cradle. You may return the Handset to its cradle whenever you're not usingthe phone.

Image 7
Contents IVrECH Optional Headset Installation and Operating Instructions Table of Contents Face-up Handset charging Battery Pack AC Power Adaptor Telephone Line CordWall Mounting Bracket Handset FCC Part Vtech CommunicationsDamage to the product Read and understand all instructionsVtech Communications Operating instructions. AdjustService DEPT. at US . Canada DamagedSlide Battery Pack IntotheDownward CompartmentReplacing a Drained Handset bat- tery Spare Battery ChargerHandset Ringer Snap the wall,mountbracket firmly Place Position the wall mount bracket on the baseIs displayed when the handset is on hold Shows the handset volume settingHanging UP ToneMaking Calls Answering CallsHold Press R kAdvanced AN.S~RRJNG~~CALLS~~.&&~Message Waiting Temporary,TonehCID-CALLER ID To select a different ringer type do the followingUnsuccessful Unit will display FollowingDial Press m t o exitEnter Private Receiving and,storirig CallsDialing from CID Memory Be shown. Releasingthe key will again To find out the corresponding phoneNumber as well as the date Call, press and holdTaking .,CARE *OF.&.YO,URJ~TEL OUT of Range When Phone is~E$&@!JLEREER~ENCE&&~ LCDTHE-HANDSET does not When YOU Receive a CallUsing Y0URPHONE.S Away ,FROMTHEBASE UnitFor HOW Long After the Original PURCHASE? What does OUR Warranty COVER?HOW do I Send MY UNIT, in or OUT of WARRANTY? What does OUR Warranty not COVER?Page Page Page Page