Spare Battery Charger, Installation | VTech VT 1922 instruction

REPLACING THE BATTERY PACK

Follow the steps below:

1.Remove the battery case cover by pressing on the ridged lines and sliding downward.

2.Discard the old battery pack. Don't put the old battery pack in a trash compactor or a fire - it could burst.

3.Place the new battery pack in its housing with the metal contacts facing down.

PLACE THE NEW

BATTERY PACK

INTO THE

BATTERY

COMPARTMENT

PLEASE NOTE THE

CORRECT POSITION

OF THE BATTERY

PACK WHEN

CHANGING BATTERY

4.Replace the battery case cover by sliding the cover upwards.

SLIDE IN THE

BATTERY

COVER

5.If the new battery pack is not already charged, place the hand- set in the cradle of the base unit to allow it to charge for 16 hours.

CAUTION:

To Reduce the Risk of Fire or Injury to parsons, read and Follow the instructions

1.Use only VTECH rechargeable battery pack.

2.Do not dispose of the battery in a fire. The cell may explode.

IMPORTANT: Do not dispose of this battery into household garbage. For information on recycling or proper disposal, consult your local solid waste collection or disposal organization.

3.Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.

4.Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets, and keys. The battery or conductor may overheat and cause burns.

To purchase replacement battery packs, call VTECH Communications at 1-800-595-9511. In Canada, call VTECH Electronics at 1-800-267- 7377.

SPARE BATTERY CHARGER

The VT 1922 has a built-in spare Battery Charger, which is located in the cradle of the Base Unit.

NOTE: In order to benefit from this feature, you must obtain an optional Spare Battery from an authorized VTech dealer, or by contacting VTech Customer Service at 1-800-595-9511 in the U.S.A and 1-800-267-7377 in canada.

Installation

Remove the Spare Battery charger cover by pressing the release tab and lifting up.

HS IN USE	CHARGING	SPAARE BATT
DIGITAL
CORDLESS900MHZ
	VT1922
	PAGE

Place a battery pack in the Spare Battery charger. Make sure the metal charging contacts on the underside of the battery pack are aligned with the charging contacts in the Spare Battery charger.

HS IN USE	CHARGING	SPAARE BATT
DIGITAL
CORDLESS900MHZ
	VT1922
	PAGE