VTech USB7200 manual Battery installation & charging, Low battery indicator

Page 6

Getting Started

Battery installation & charging

Install batteries as shown below, plug in the charger, then place the handset in the charger for 15 hours before first use. You can keep batteries charged by placing the handset in the charger after each use. When batteries are fully depleted, a full recharge takes 15 hours.

Note: The screen will be blank until the batteries are charged enough to activate it.

BATTERY LOW

PLACE IN CHARGER

Press here and pull down to remove cover.

Low battery indicator

Return handset to base or charger when this symbol appears. (Handset will beep when battery is low.)

Insert supplied batteries

Caution: Do not use alkaline batteries. Use only the batteries that came with your phone, or contact our Customer Support Center to order additional batteries.

Plug charger into an outlet not controlled by a wall switch.

Charge batteries for 15 hours before first use.

Replace cover

4

Image 6
Contents USB Page Table of contents Quick reference guide Parts checklist Belt clip & optional headsetBattery installation & charging Low battery indicatorUsing your new handset Registering your new handsetCase of difficulty Care and maintenance Important safety instructions Important safety instructions What is not covered by this limited warranty? WarrantyWhat does this limited warranty cover? How long is the limited warranty period?Other Limitations FCC, Acta and IC regulations FCC PartFCC and Acta Information Connection and use with the nation- wide telephone network IC Industry Canada Issue