Setup
Connecting power to Base Unit
Plug the AC power adapter into an electrical outlet, and the DC connector into the bottom of the Base Unit.
| CANADA xxxxxxxxxxxxx REN/IES: 0.1 | ||
| IC: xxxxxxxxxx | HAC | FCC ID: xxxxxxxx |
CORDLESS TELEPHONE | COMPLIES WITH 47 CFR Part 68 |
|
|
MANUFACTURED IN CHINA | FCC REGISTRATION NO.: xxxxxxxxxxxxxxxx | ||
MODEL: 2458 | RINGER EQUIVALENCE: 0.1B |
|
|
DC 9V 500mA | USOC JACK: RJ11C,RJ11W |
|
|
CLASS 2 POWER SOURCE ONLY | THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. | ||
| OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: | ||
1)THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE; AND 2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
PRIVACY OF COMMUNICATIONS MAY NOT BE ENSURED WHEN USING THIS PHONE.
Installation of Battery Pack in Handset
Follow the steps below:
1.Remove the battery cover by pressing on the indent and sliding downward.
Getting Started
1 |
2 |
2.with the red and black wires at the bottom right corner of the pack, angle the top of the battery into the compartment, under the two ‘claws’. Next, press the lower end of the battery pack down, so it snaps in place, under the lower claw. Now, plug the connector into the socket, located below the battery. Slip the wires under the wire guide, located below and to the left of the socket.
3.Replace the battery cover by sliding it upwards.
4.If the new battery pack is not already charged, place the Handset in the Base Unit, and allow it to charge for 12 hours. After the initial charge, a maintenance charge of 8 hours should be sufficient. Maximum talk time is 5 hours on a full charge. Maximum standby time is 5 days.
3