VTech 2625 Getting Started, Installation and Charge of Battery Cells in Handset

Page 7

Setup

2.Choose the location for your Handset Charger, and plug its power supply into an electrical outlet.

To AC outlet

CORDLESS TELEPHONE

VTECH TELECOMMUNICATIONS LTD.

DC 9V 150mA

CLASS 2 POWER SOURCE ONLY

Installation and Charge of Battery Cells in Handset

Follow the steps below:

1.Place the new battery cells in the Handset with the positive and negative poles aligned in the battery compartment.

2.Replace the battery cover by sliding it upwards

3. If the new battery cells are not already charged, place the Handset in its Charger or Base Unit, and allow it to charge for 10-12 hours. After initial charge, a maintenance charge of 8 hours should be sufficient.

WARNING: Alkaline batteries must NOT be used in your ev 2625 cordless telephone. Use only the batteries that came with your phone, or contact our Customer Support Center (contact information on page 2) to order additional batteries.

Charging of the Handset Battery Cells

The Handset of your cordless telephone is powered by rechargeable battery cells. It charges automatically whenever the Handset is in its charger or Base Unit.

You should charge the battery cells for at least 12 hours when you first receive your phone. You’ll know the battery cells needs charging when:

The low battery message and the icon are

LOW BATTERY

 

displayed.

The Handset seems completely dead, the

 

 

LCD is completely clear and does not

 

 

activate when you press the keys.

 

NOTE: When in LOW BATTERY mode, the keypad sounds, backlighting and speakerphone features will not work. When your battery has been charged, your features will return to their normal function.

Getting Started

7

Image 7
Contents Important Safety Instructions Vtech Communications INC Introduction Parts Check List Handset Layout Connecting Power to Base Unit/Handset Charger SetupGetting Started Base Unit Layout Charging of the Handset Battery Cells Installation and Charge of Battery Cells in HandsetGetting Started Checking for Dial Tone Getting Started SetupCheck Battery Indicator Connecting to Phone LineHandset LEDs Handset and Base IndicatorsBasic Operation Handset IconsHandset Operation Basic Operation Call Forward and Call Transfer Handset OperationMute Function Intercom CallCall Transfer Call ForwardConference Call Base Operation Storing a New Entry Phonebook OperationKey Characters by number of key presses Reviewing/Dialing from the Phonebook Phonebook Operation Basic OperationEditing a Phonebook Entry Delete a Phonebook Entry Caller ID Call Waiting ID Basic Operation Calls Log Caller ID Call WaitingReviewing Caller ID Basic OperationStoring a Caller ID Deleting Caller ID Dialing from Caller IDRinger Tone Handset SettingsRinger Volume Key Tone preset to onLanguage preset to English Handset Name preset as ‘VTECH’Clear Message Waiting Dial Type preset to ToneBelt Clip Advanced Operation Headset OperationAdditional Information Additional Information Case Of DifficultyCommon Cure For Electronic Equipment Maintenance How long is the limited warranty period? What does this limited warranty cover?What is not covered by this limited warranty? Other Limitations How do you get warranty service?FCC Part 68 and Acta FCC PartRepair instructions Programming/testing of emergency numbersProduct identifier and REN information Connection and use with the nationwide telephone networkIC Industry Canada FCC, Acta and IC Regulations Technical Specifications Member of the Vtech Group of Companies Table of Contents Advanced Operation Headset Operation