6.2.4.Configure the Juniper VF 3000 SBC
The following section describes how to configure the Juniper VF 3000 SBC for LSP enterprise sites. Only the Signaling Card (SC) needs to be updated, not the Media Card (MC). In a High Reliability (HA) configuration, both the master and backup (SC) needs to be updated. This document assumes that Juniper VF 3000 SBC basic provisioning has been performed. Refer to [2] for more information. The steps below are for enterprise site B1.
Connect to the (SC) interface of the Juniper VF 3000 SBC via the console port or telnet to the management interface, which should already be administered.
Step 1. Enter “privileged” mode to input configuration and management commands. Enter the “privilege” mode password. Enter command blade
Figure 45
TC; Reviewed: | Avaya – Proprietary | 54 of 61 |
PV 04/24/2006 | Use as authorized only pursuant to your signed agreement or | |
| Avaya policy. No other disclosure is permitted or authorized. |
|