APC CP16, CP27 user manual Connect Equipment and Power, Optional Runtime Extension

Page 7

Connect Equipment and Power

The PowerShield battery charges when it is connected to utility power. The battery charges fully during the first eight hours of normal operation. Do not expect full battery run capability during this initial charge period.

Utility Power

Cord Inlet

Output Power and

Optional Runtime

Communication

Extension Connector

Signals

 

 

1.Connect the PowerShield to the application equipment (example: FTTH/P Optical Network Terminal) via the seven-pin output connector, using the appropriate cable (must be ordered separately). See www.apc.com for a list of available output cables.

2.Plug the PowerShield power cord into the utility power cord inlet and then into the wall outlet.

Do not overload the wall outlet or circuit.

Cold Start Feature: Upon installation of a charged battery, power will immediately be applied to the unit even when utility power is not present.

Optional Runtime Extension

The runtime may be extended by adding the external battery CP20B12BP.

5

Page 6 Page 8
Image 7
Page 6 Page 8
Contents
Models CP16 and CP27 Broadband PowerShieldPage Unpacking SafetyBattery Warning General InformationPhysical SpecificationsGeneral EnvironmentalEnclosure Installation Installation$ % Battery InstallationOptional Runtime Extension Connect Equipment and PowerDo not overload the wall outlet or circuit Front Panel Status Indicators and FeaturesAudible Alarm OperationAlarm Silence Button Output Power and Communication SignalsFunction Button Operation Description Press and hold for Battery Replacement Maintenance, Service, Approvals, and WarrantyService Contact Information Regulatory Approvals Limited Warranty