Chapter 2 Configuring the Cisco Unified IP Phone for MIDlets
Configuring the Cisco Unified IP Phone
Managing Cisco Unified IP Phones
Before You Begin
Before starting the following procedure, note the MAC address of the Cisco TelePresence phone device. See the Before You Begin section for information about determining the MAC address.
Note You must restart your system after you have completed the configuration tasks in this section.
Use the tasks in this section to configure the Cisco Unified IP Phone for MIDlets. When you are finished configuring your settings, click Save and follow the prompts to restart the system.
To configure the Cisco Unified IP phone:
Step 1 Log in to the Cisco Unified CM Administration interface.
Step 2 From the Device
Tip Search for a device type that contains “7970” or “7975.”
Step 4 Click Find. A list of devices appears.
Step 5 Click on a device in the Device Name (Line) column. The Phone Configuration page for that device appears.
Step 6 In the Phone Type box, verify the following requirements:
•Phone Type—Cisco 7970, Cisco 7971, or Cisco 7975
•Device
Step 7 Enter information in the following sections found on the Phone Configuration page to configure the Cisco IP Phone 7970 Series:
•Device Information, page
•Protocol Specific Information, page
•Certification Authority Proxy Function (CAPF) Information, page
•Expansion Module Information, page
•External Data Locations Information, page
•Extension Information, page
•MLPP Information, page
•Do Not Disturb, page
•Secure Shell Information, page
•Product Specific Configuration Layout, page
Device Information
Enter the settings to configure the Cisco Unified IP Phone 7970 Series using the information in Table
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
|
| ||
|
|