Choose System Ldap Ldap Directory | Cisco Systems OL-20852-01

Appendix D Basic Phone Administration Steps

Adding a User to Cisco Unified Communications Manager

This section describes steps for adding a user to Cisco Unified Communications Manager. Follow one of the procedures in this section, depending on your operating system and the manner in which you are adding the user:

•Adding a User From an External LDAP Directory, page D-2

•Adding a User Directly to Cisco Unified Communications Manager, page D-2

Adding a User From an External LDAP Directory

If you added a user to an LDAP Directory (a non-Cisco Unified Communications Server directory), you can immediately synchronize that directory to the Cisco Unified Communications Manager on which you are adding this same user and the user’s phone by following these steps:

Procedure

Step 1 Login to Cisco Unified Communications Manager Administration.

Step 2 Choose System > LDAP > LDAP Directory.

Step 3 Use the Find button to locate your LDAP directory.

Step 4 Click the LDAP directory name.

Step 5 Click Perform Full Sync Now.

Note If you do not need to immediately synchronize the LDAP Directory to the Cisco Unified Communications Manager, the LDAP Directory Synchronization Schedule on the LDAP Directory window determines when the next auto-synchronization is scheduled. However, the synchronization must occur before you can associate a new user to a device.

Step 6 Proceed to “Configuring the Phone” section on page D-3.

Adding a User Directly to Cisco Unified Communications Manager

If you are not using an LDAP directory, you can add a user directly to Cisco Unified Communications Manager Administration by following these steps:

Procedure

Step 1 Choose User Management > End User.

Step 2 Click Add New.

The End User Configuration window appears.

Step 3 In the User Information pane of this window, enter the following:

Cisco Unified IP Phone 6901 and 6911 Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP)

	D-2	OL-20852-01