Ramsey Electronics manual SA7 layout

Page 4

REQUIRED, NOT SUPPLIED

8-15 VDC power source

your choice of power on-off switching

RF input and output connectors (your choice of type)

enclosure of your choice, if SA7 is not mounted inside receiver or counter, etc.

SA7 layout

SA7—4

Image 4

Contents Broadband RF Preamp SA7 Introduction Parts Supplied with SA7 KIT SA7 layout SA7 PRE-AMP Assembly Procedure STEP-BY-STEP PC Board AssemblySA7-6 SA7-7 SA7-8 Using Your SA7 PRE-AMP Ramsey PR2 Ultimate Broadband PRE-AMPFinal Notes about Broadband PRE-AMPS Broadband Active Antenna Adding a Tuned RF InputSA7 ANT SA7-13 Ramsey Kit Warranty Factory Repair of Assembled Kits Call or write for our