Ramsey Electronics manual Testing Your PPM3

TESTING YOUR PPM3

Now it’s time to see all your hard work pay off. Here’s what you’ll need to test and use your PPM3

•An 8 to 15 volt DC power supply, positive tip

•CD player or other device to provide a line level audio input to the PPM3

•A stereo or other device that has line level inputs

•A microphone

•A telephone with phone line attached

•A length of standard phone line cable

•An RCA cable to connect your line level audio source to the PPM3

•An RCA cable to connect the output of the PPM3 to your stereo or other line level device for testing and eventually for connecting to your transmitter.

We assume that you’ve carefully checked over your construction before connecting power and energizing the circuit. Yes, we warned you! If you run into problems at any point, move straight to the troubleshooting section.

ˆ1. Turn all volume pots (R12, R2, and R15) to minimum (counterclockwise)

ˆ2. Connect your 8 to 15 volt DC power source to J4

ˆ3. Turn on your PPM3; the green power LED should light

ˆ4. Connect your RCA cable from the line level source to the dual RCA jack labeled “Input” on the back of the PPM3

ˆ5. Connect your RCA cable from the dual RCA labeled “Output” on the PPM3 to your stereo or other audio device with a line level input. This will be used to test the audio section of the PPM3. Later you’ll disconnect the stereo and use the output from the PPM3 as the line level stereo audio source for your transmitter.

ˆ6. Make sure your line level audio source is operating and you have a suitable level of audio going to the PPM3. With the PPM3 turned on and the volume on the stereo at a comfortable listening level, slowly turn R2 clockwise to increase the volume on the PPM3 until you can hear the audio coming through. You should be able to vary the audio level with R2 and also see the “Clip” LED light with peaks in the music.

ˆ7. Next connect your microphone to the “Microphone Input” on the PPM3. Now push the “Mic” button; the red LED should light. Speak into the microphone and vary the volume using the “Mic Volume” knob.

PPM3 Page 21