I N S T A L L A T I O N
Base Antenna (extended)
CHARGING |
|
|
|
|
|
|
| ||
HANDSET | IN | USE | MEMO/REWIND |
|
|
|
|
|
|
|
|
|
|
|
|
| CLOCK | Lift panel door | |
|
|
|
| FAST |
|
|
| ||
|
|
|
| FWD |
|
|
| ||
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
| SAVE |
|
| to access features |
|
|
|
|
|
|
| PLAY/STOP |
| |
|
|
|
|
|
|
|
| (see figure at right). | |
|
|
|
|
|
|
|
|
| |
Cover
Turn system 
on or off.
Record or play outgoing anouncement
Fast forward during message playback.
VOLUME | Audible clock; also use with | |
CHANGE to set time/day. | ||
| ||
| Adjust message playback volume. |
Play messages or
stop message playback
Save messages.
Use with other buttons to change settings
should be on steady. If the light is flashing rapidly, the microcassette is not installed properly. Remove the cassette, and check to see if it's damaged. It it's okay, install it again. After you have installed the cassette, press PLAY/STOP to reset the system.
CAUTION: Use only the power supply provided with this prod- uct. To obtain a replacement, call Lucent
Technologies at 1 800
Output: 9V AC, 780 mA.
8Charge the handset batteries be- fore use.
Place the handset face down in the base. The CHARGING light on the
base goes on to show the handset is in the right position to charge the batteries. The batteries will be fully charged in 14 hours.
9Check for dial tone.
Make sure the base antenna is upright. After the batteries are charged, pick up the handset and check for dial tone by pressing P; the PHONE light should go on and you should hear a dial tone. Press Pto hang up.
10Set the dial mode.
If you have touch tone service, the phone will be ready to use as soon as the battery is charged.
If you have dial pulse service, you’ll need to set the dial mode. Press
P(wait for dial tone), p,
#, #, #. 3. To return to touch tone dialing with touch tone service, when the phone is off, press P (wait for dial tone), p, #, #,
#, 8.
IMPORTANT: After you have installed the 7610, you will need to record an announcement that callers will hear when the system answers. Please see the Answering System Operation section of this manual.
2