AT&T 847868304, CDLS 7610 user manual E R a T I N G R a N G E, Changing Channels

Page 9

O P E R A T I N G R A N G E

This cordless telephone operates at the maximum power allowed by the Federal Communications Commission (FCC). Even so, the handset and base can com- municate over only a certain distance — which can vary with the locations of the base and handset, the weather, and the construction of your home or office.

When you make a call, if the handset is at to a point where the base and handset can not communicate, the handset will sound two short beeps, indicating that you are out of range. Move closer to the base to re- store normal operation.

If you receive a call while you are out of

range, the handset might not ring — or if it does ring, the call might not connect when you press P. Move closer to the base, then press Pto answer the call.

If you move out of range during a phone conversation, you will hear noise or inter- ference. To improve reception, move closer to the base.

If you move out of range while on a call, the phone will be left “off the hook.” To hang up properly, walk back into range, periodically pressing P until the PHONE light goes off.

Changing Channels

This cordless telephone has an advanced 25-channel AutoSelect® feature that mini- mizes the chance of interference. Every time you answer or make a call, the AutoSelect feature searches for and selects a clear channel.

In the unlikely event that you notice noise or interference while using the handset:

1Press C.

2If the interference does not clear, continue to press Cuntil you find a clear channel (your call will not be interrupted

—OR—

Move closer to the base and press C.

NOTE: You must be in range to change channels.

8

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Read Part 1 Important Product Information For Cordless Answering System TelephoneInstall the handset battery InstallationConnect the power cord Mount the base on the wallSet the dial mode To access featuresLift panel door Charge the handset batteries be- fore useT T E R I E S Charging Handset Battery PackIf the phone does not ring when you receive a call If you hear noise or interference when using the phoneC a S E O F D I F F I C U L T Y If the phone does not work at all, check these items firstIf the system does not respond to remote commands If you have difficulty hearing messagesIf the recording tape sticks or malfunctions E R a T I O N M O R Y E R a T I N G R a N G E Changing ChannelsIf you receive a call while you are out Setting the Clock Volume ControlAnswering System Operation Recording Your AnnouncementRing Select When the Tape is FullAnswering Calls Bypassing AnnouncementChanging Your Remote Access Code Remote Access CodeRecording a New Announcement Turning System OnOperation From a Remote Touch Tone Phone Answering SystemCommand Page Page Page Page Page Page Page
Top Page Image Contents