AT&T 9050 Batteries, Charging the Handset Battery Pack, Charging the Spare Battery Pack

Page 24

BATTERIES

CAUTION: To reduce the risk of fire or injury to persons or damage to the telephone, read and follow these instructions carefully.

Use only Replacement Battery 3470.

Do not dispose of the battery in a fire. The cell might explode. Check with local codes for special disposal instructions.

Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.

Exercise care in handling batteries in order not to short the battery pack with conducting materials such as rings, bracelets, and keys. The battery pack or conductor may overheat and cause harm.

Charge the battery provided with or identified for use with this product only in accordance with the instructions and limitations specified in this manual.

Make sure the battery is inserted properly so the metal contacts on the battery are aligned with the charging contacts in the battery compartment.

Charging the Handset Battery Pack

The batteries need charging when:

The LOW BATT light on the handset is on.

The phone does not respond when you press P, and no lights go on.

Place the handset in the base so the CHARGING light goes on. The batteries will be fully charged in 10 hours (16 hours for first charge).

NOTE: For optimum battery performance, do not place the handset in the base until the LOW BATT indicator lights.

Charging the Spare Battery Pack

The spare battery charging compartment is located in the base cradle. You can use the spare battery pack to replace the current handset battery pack right away if it becomes depleted. The spare handset battery pack is optional, and must be purchased separately.

22

9050_book.1AT&T

22

8/12/98, 4:15 PM

Image 24
Contents User’s Manual for Cordless Telephone Answering System Philips Consumer Communications L.P. All rights reserved Contents 9050book.1AT&T 12/98, 414 PM Installation Table/Desk InstallationSet the dial mode Wall Installation Connect the power cordConnect the telephone line cord Charge the handset batteries for 16 hoursFollow Steps 6 and 7 under Table/Desk Installation Belt ClipMount the telephone on the wall Operation Operation Making a Call Answering a CallEnding a Call RedialHandset Volume Special Telephone ServicesTemporary Tone Page/Handset LocatorHeadset Jack Operating Range Telephone Memory Answering System Setup VolumeSetting the Clock Turning the System ON/OFFAnnounce Only Mode Selecting Your AnnouncementRecording Your Announcement Ring Select and Toll Saver Audible Message AlertTo return to the prerecorded announcement Remote Access Code Base Ringer SettingAnswering System Operation AT the BaseAnswering Calls Call Screening/InterceptListening to Your Messages Saving Messages Deleting Messages Recording a Memo Delete all messagesRemote Access Commands Connect with the Answering SystemVoice Help Menu Playing MessagesRemote ON/OFF Charging the Handset Battery Pack Charging the Spare Battery PackBatteries Replacing the Handset Battery Pack If you hear noise or interference when using the phone Case of DifficultyIf the phone doesn’t work at all, check these items first If the phone does not ring when you receive a call If you hear other calls while using your phoneIf messages are incomplete If you have difficulty hearing messagesIf your outgoing announcement isn’t clear Cordless Telephone Answering System Connect with Answering SystemOption Press