AT&T 9340 user manual Batteries, Charging the Handset Battery Pack

Page 22

BATTERIES

Charging the Handset Battery Pack

This battery should remain charged up to 15 days with the Ringer turned on and up to 30 days with the Ringer off. A fully charged battery provides an average talk time of about 12 hours.

The battery pack needs charging when:

A new battery is installed in the handset.

The phone beeps four times when you press P.

The battery status symbol on the screen is only partly displayed.

The phone does not respond when you press P.

Place the handset in the base either in the face-down or face-up position so the CHARGING/HANDSET IN USE light turns on. The battery pack is typically fully charged in six hours.

You can keep the battery fully charged by returning the handset to the base after each use.

If you repeatedly get a low battery indicator, even after six hours of charging, the battery should be replaced.

CAUTION: To reduce the risk of fire or injury to persons or damage to the telephone, read and follow these instructions carefully:

Use only Replacement Battery 3300 (SKU# 90556).

Do not dispose of the battery in a fire. The cell might explode. Check with local codes for special disposal instructions.

Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.

Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets, and keys. The battery or conductor may overheat and cause harm.

Charge the battery provided with or identified for use with this product only in accordance with the instructions and limitations specified in this manual.

Observe proper polarity orientation between the battery and battery charger.

20

AT&T 9340 book_1ATT

20

11/3/98, 12:41 PM

Image 22
Contents Revised 11/3/98 Philips Consumer Communications L.P. All rights reserved Contents AT&T 9340 book1ATT 11/3/98, 1239 PM Installation Connect the telephone line cordMount the base on the wall Belt Clip Dial Mode Feature SetupAbout Softkeys Ringer Off / Battery Save Handset Ringer SelectionProgramming Home and Local Area Codes Turning Off Caller ID with Call WaitingMessage Waiting Indicator Call List OptionsMaking a Call Telephone OperationPreview a Number Before Calling Ending a Call Handset VolumeAnswering a Call RedialFlash MuteHandset Locator Changing Channels Headset JackStoring Numbers In Memory Telephone MemoryMemory Guard Storing a Name with a NumberViewing Numbers in Memory Replacing a Stored NumberStoring a Pause in a Memory Number Deleting/Editing Memory NumbersPriority Ring Numbers Dialing Memory NumbersCall Waiting Caller ID OperationAbout Caller Identification NEW Call LightReviewing Call History Incoming Call HistoryDisplay Dial Deleting Call Records from call history Caller ID Display MessagesCharging the Handset Battery Pack BatteriesReplacing the Handset Battery Pack Operating Range Case of Difficulty If the phone does not work at all, check these items firstIf you hear noise or interference when using the phone If the caller’s name or phone number is not displayed