AT&T 9340 user manual Installation, Connect the telephone line cord

Page 5

INSTALLATION

Standard electrical outlet

Modular telephone jack

Strain-relief

groove

Long telephone line cord

Power cord

The instructions below are for both table and wall installation.

1Choose a spot near an electrical outlet and a telephone jack. This phone requires a modular telephone jack and a standard electrical outlet (110v AC) not controlled by a wall switch.

2Install the handset battery.

(For an illustration of battery installation, see the BATTERIES section in this manual.)

•Remove the battery cover by pressing on the indentation and sliding downward.

•Plug the battery pack connector into the handset, and place the battery pack and wires into the compartment.

•Replace the battery cover by sliding it on its track up over the battery compartment until it snaps firmly into place.

3Connect the telephone line cord.

Make sure the plugs snap firmly into place. (If you are wall mounting the phone, use the short line cord, and press the excess cord into the groove on the bottom of the base.)

4Connect the power cord as shown above.

NOTE: Connect power to the base unit before placing the handset in the cradle.

3

AT&T 9340 book_1ATT

3

11/3/98, 12:40 PM

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Revised 11/3/98 Philips Consumer Communications L.P. All rights reserved Contents AT&T 9340 book1ATT 11/3/98, 1239 PM Connect the telephone line cord InstallationMount the base on the wall Belt Clip About Softkeys Feature SetupDial Mode Handset Ringer Selection Ringer Off / Battery SaveTurning Off Caller ID with Call Waiting Programming Home and Local Area CodesCall List Options Message Waiting IndicatorPreview a Number Before Calling Telephone OperationMaking a Call Answering a Call Handset VolumeEnding a Call RedialHandset Locator MuteFlash Headset Jack Changing ChannelsMemory Guard Telephone MemoryStoring Numbers In Memory Storing a Name with a NumberStoring a Pause in a Memory Number Replacing a Stored NumberViewing Numbers in Memory Deleting/Editing Memory NumbersDialing Memory Numbers Priority Ring NumbersAbout Caller Identification Caller ID OperationCall Waiting NEW Call LightDisplay Dial Incoming Call HistoryReviewing Call History Caller ID Display Messages Deleting Call Records from call historyBatteries Charging the Handset Battery PackReplacing the Handset Battery Pack Operating Range If the phone does not work at all, check these items first Case of DifficultyIf you hear noise or interference when using the phone If the caller’s name or phone number is not displayed
Top Page Image Contents