I N S T A L L A T I O N
Modular jack
AC Adapter
Power cord
Telephone line cord
FOR TABLE/DESK INSTALLATION
1Choose a spot near an electrical outlet and a telephone jack.
This phone requires a modular telephone jack and a standard electrical outlet (110v AC).
2Install the handset battery.
a Plug the battery pack connector into the handset and place the battery pack into the case, so the wires rest between the battery pack and the case.
b Place the battery case cover on the handset by sliding it on its track up over the battery case until it snaps firmly in place.
3Set the RINGER switch.
Set the switch on the side of the handset to ON so the handset will ring. When this switch is set to OFF the handset will not ring.
NOTE: If you set the RINGER switch to OFF, the handset bat- tery will last longer. However, when the RINGER is set to OFF, no incoming call information will appear in the display, and the handset will not ring or page.
5Connect the power cord.
Plug the power cord into the jack labeled POWER on the back of the base. Plug the AC adapter on the power cord into an electrical outlet.
6Charge the handset batteries before use.
Place the handset face down or face up in the base. The CHARGING light on the base goes on to show the handset is in the right position to charge the batteries. Model 7710 requires 10 hours of charge time.
7Set the dial mode.
If you have tone service, the phone will be ready to use as soon as the battery is charged. If you have dial pulse service, you’ll need to set the dial mode.
aPress MENU .
bUse the softkey to select SETUP (see "About Softkeys" in TELEPHONE OPERATION, Panel 3).
cUse the softkey and continue to select NEXT until the screen displays DIAL MODE:TONE.
dUse the softkey to select CHANGE. The screen displays DIAL MODE:PULSE.
ePress MENU to exit.
4Connect the telephone line cord.
Plug one end of the telephone line cord into the jack labeled TEL LINE on the back of the base. Plug the other end of the line cord into a modular phone jack. Make sure the plug snaps firmly in place.
To change back to tone dialing, follow steps a to d.
1