AT&T 9312 user manual Replacing the Handset Battery Pack

Page 21

BATTERIES

Nickel-Cadmium Rechargeable Batteries must be recycled or disposed of properly. Do not dispose of in household garbage. If burned, it could explode. If punctured, it could release caustic material which could injure the skin or eyes. If swallowed, it may be toxic.

The RBRC™ seal means that the manufacturer is voluntarily participating in an industry program to collect and recycle Nickel-Cadmium rechargeable batteries when taken out of service within the United States. These batteries may be taken to a participating local retailer of replacement batteries or recycling center. Or, you may call 1–800–8BATTERY for locations accepting spent Nickel-Cadmium batteries.

Replacing the Handset Battery Pack

1Remove the battery compartment cover on the handset by pressing on the indentation and sliding the cover downward.

2Lift out the old battery pack and disconnect.

3Plug the new battery pack connector into the handset. Place the battery pack and its wires into the battery compartment.

4Replace the cover by sliding it up into place.

5The new battery pack must be charged before using the phone. Place the handset in the base and allow it to charge for at least

16 hours the first charge. The telephone might operate before that, but for best performance, let the battery pack charge fully.

RBRC is a registered trademark of the Rechargeable Battery Recycling Corporation.

19

Page 20 Page 22
Image 21
Page 20 Page 22
Contents
Part 1 Important Product Information MHz Two-Line Cordless SpeakerphoneAdvanced American Telephones. All rights reserved Contents Page Installation Before You InstallInstall the handset battery Set the dial mode Select base ringer volume for each lineAttach the belt clip to the cordless handset optional Table/Desk Installation Connect the power cordConnect the telephone line cords Charge the handset battery Wall InstallationCheck for dial tone Position the wall mount adapter on the baseInstallation Mount the base on the wall Follow Steps 3-4 in Table/Desk InstallationTelephone Operation Temporary Tone Dialing Handset Ringer StyleRinger Off Intercom Calls Intercom Call SignalsConference Calls Four-Way Conference CallsHeadset Jack Switching from Handset to Base SpeakerphoneOperating Range Mute Make or Answer a CallFlash Call Waiting Speakerphone Volume Base Ringer Volume Redial HoldSwitching from Base Speakerphone to Handset To make an intercom call to the handsetTo answer an intercom call from the handset Store Memory Numbers Telephone MemoryStore a Pause in a Memory Number Change/Replace a Stored Memory NumberBatteries Charging the Handset Battery PackReplacing the Handset Battery Pack Cover Spare Battery ChargerIf the handset does not ring when you receive a call Case of DifficultyIf the phone doesn’t work at all, check these items first If you hear noise or interference when using the phone If the base does not ring when you receive a callIf you hear other calls while using your phone If you lose a call after changing channels
Top Page Image Contents