Intercom Calls, Conference Calls, Intercom Call Signals

AT&T 9312 user manual Intercom Calls, Intercom Call Signals, Four-Way Conference Calls

Page 13

TELEPHONE OPERATION

AT THE HANDSET

Intercom Calls

You perform the same steps to make and answer intercom calls.

1Press ion the handset.

2When the person at the base answers, speak into the handset.

3Press Owhen finished.

If you make an intercom call when you’re already on a phone call, the phone call is automatically placed on hold.

Intercom Call Signals

The handset beeps once to signal an incoming intercom call when you’re on an outside call. The handset rings repeatedly (up to 60 seconds) when you’re not on an outside call.

Conference Calls

You can use both lines at the same time to set up a three-way conference call from the handset.

1Answer or make a call on one line.

2Press the other LINE button, and make or answer another call (your first call is automatically put on hold).

3Press cto connect all parties. Both LINE buttons are lit during a conference call.

4Press Oto end the entire conference call.

NOTE: If you want to end the call with just one side of a conference call, press that LINE button, press O, and then press the other LINE button to speak with the other party.

Four-Way Conference Calls

You can set up a four-way conference call with Line 1, Line 2, the handset, and the base speakerphone.

1Establish a conference call at the handset (see “Conference Calls” above).

2Press Lon the base.

3Press lon the base.

4Press con the base to connect all parties.

Image 13

Contents

Part 1 Important Product Information MHz Two-Line Cordless SpeakerphoneAdvanced American Telephones. All rights reserved Contents Page Before You Install InstallationInstall the handset battery Select base ringer volume for each line Set the dial modeAttach the belt clip to the cordless handset optional Connect the power cord Table/Desk InstallationConnect the telephone line cords Charge the handset battery Wall InstallationCheck for dial tone Position the wall mount adapter on the base Installation Mount the base on the wall Follow Steps 3-4 in Table/Desk InstallationTelephone Operation Handset Ringer Style Temporary Tone DialingRinger Off Intercom Calls Intercom Call SignalsConference Calls Four-Way Conference CallsHeadset Jack Switching from Handset to Base SpeakerphoneOperating Range Make or Answer a Call MuteFlash Call Waiting Speakerphone Volume Base Ringer VolumeRedial HoldTo make an intercom call to the handset Switching from Base Speakerphone to HandsetTo answer an intercom call from the handset Store Memory Numbers Telephone MemoryStore a Pause in a Memory Number Change/Replace a Stored Memory NumberBatteries Charging the Handset Battery PackReplacing the Handset Battery Pack Cover Spare Battery ChargerCase of Difficulty If the handset does not ring when you receive a callIf the phone doesn’t work at all, check these items first If you hear noise or interference when using the phone If the base does not ring when you receive a callIf you hear other calls while using your phone If you lose a call after changing channels

AT&T 9312 user manual Intercom Calls, Intercom Call Signals, Four-Way Conference Calls