Installation

NOTE: This telephone requires a modular telephone jack.

Table

If you have a wall-mounted telephone, remove the telphone from the wall and follow these instructions:

1Remove the base.

2Connect line cord to telephone. Plug the line cord into the LINE jack on the bottom of the telephone.

3Attach the base.

Turn the base so that the larger end of the base is toward the top of the telephone. Attach the base by inserting the tabs into the slots. Push down on the large end of the base to lock it into place.

4Connect the line cord to your modular jack.

Plug the free end of the line cord into a modular jack. Make sure it snaps firmly into place.

5Connect handset to telephone. Plug the coiled cord into the hand- set jack on the side of the phone. Plug the other end of the coiled cord into the handset, and then hang up.

6Check for dial tone.

Lift the handset and listen for a dial tone. If you cannot hear a dial tone, turn to “In Case of Difficulty.”

Wall

1Remove the base.

2Connect the line cord to telephone.

Do not unbundle line cord. Plug the seven-foot line cord into the LINE jack on the underside of the phone. Leave enough cord free to connect to the wall jack, but keep any excess cord bundled. Store the bundled cord in the open area under the set.

3Attach the base.

Turn the base so that the larger end of the base is toward the bot- tom of the telephone. Attach the base by inserting the tabs into the slots. Push down on the large end of the base to lock it into place.

4Reverse handset tab.

To mount the telephone on a wall, you must reverse the handset tab. This tab holds the handset when you hang up.

Hold down the switchhook, and slide the tab up and out of its slot (Figure 1A). Turn the tab so that the curved end is up (Figure 1B). Then insert the tab back into its slot (Figure 1C).

5Connect the line cord to modular wall jack and mount phone onto wall jack.

Make sure the cord snaps firmly into place. Place the phone on the wall jack mounting studs and pull down until it is held securely.

Follow Steps 5 and 6 under “Table” Installation.

Dial Mode Selection

This telephone will work with tone or dial pulse (rotary) service. Even when set to dial pulse service, the phone can be switched temporarily to tone, for access to services that require tone signaling, including some tone-activated computer systems.

This product comes set in the touch-tone mode. Make sure you choose the correct dialing method; touch-tone dialing will not work if you have dial pulse service.

After the telephone is plugged in, if you have dial pulse (rotary) service,

lift handset and press , ,