Uniden FP 107 manual Advanced Features, Setting the Display Contrast, Using Call Breakthrough

Page 21

NOTE

The FP107 has ten (0–9) display contrast settings.

NOTE

If you do not complete each step within 8 seconds, the FP107 exits setup. Start again from Step 1.

NOTE

If the FP107 Answer Machine is off, after 15 rings it will automatically switch on and answer the call.

NOTE

If you do not enter a digit within 8 seconds, the FP107 hangs up.

ADVANCED FEATURES

Setting the Display Contrast

1.Hold down store until the FP107 beeps once. 5 and LCD CONTRAST appear. 5 flashes.

2.Repeatedly pressorto select the desired display contrast settings.

3. Press store to confirm the setting, then press stop to return to the time display.

Using Call Breakthrough

If you screen your calls but want to know when calls come in from certain people, give them your Call Breakthrough (CBT) Code.

When a caller enters the CBT code during the outgoing message (168 factory preset), the FP107 alerts you with a series of loud beeps for 35 seconds. To answer the call, pick up the handset or press speaker . If you do not answer, the caller can leave a message after the outgoing message plays.

Changing the CBT Code

The CBT code is preset to 168, but you can change it by following these steps: 1. Hold down store until the FP107 beeps once.

2.Press store two times. 168 and SET CBT CODE are displayed.

3.Enter the new 3 digit code.

4. Press store then press stop to return to the time display.

Remote Operation

You can operate the FP107 from almost any touch-tone phone or from a rotary phone using a pocket tone-dialer.

Follow these steps to operate the FP107 remotely.

1.Dial your phone number from another phone.

2.When the FP107 answers, enter your remote operation security code (705 factory preset). The FP107 beeps once to confirm that you entered the correct code.

3.Enter a remote command (see “Remote Command List”).

4.When you finish, hang up.

Changing the Remote Operation Security Code

The FP107's remote operation security code is preset to 705, but you can change it by following these steps.

1. Hold down

store until the FP107 beeps once.

2. Press store

once. 705 and SECURITY CODE are displayed. 7 flashes.

3. Enter the new 3 digit code.

4. Press store then press stop to return to the time display.

20

Image 21
Contents OWNER’S Controls & Functions 02-9599-3355 Contents Start Installing Backup Battery Answer Machine Features FeaturesSupplied with Your FP107 OWNER’SWall Mounting Wall InstallationRinger volume control Handset volume controlSpeaker volume control Using Redial Making a CallAnswering an Incoming Call Using Flash Using HoldUsing Mute Storing Numbers from Caller ID Records Storing a Number in MemoryEntering a Pause in a Memory Number Reviewing Memory NumbersDialing a Memory Number Call Diversion Chain-DiallingRecording Outgoing Messages Telephone Answer DeviceSetting the FP107 to Answer Calls Using the Toll SaverChecking the Outgoing Message Number of RingsCaller ID Operation Caller ID MessagesName Tagging Deleting Call Records Reviewing Caller ID RecordsPlaying Messages FP107 OperationDeleting Messages Screening CallsSetting the Display Contrast Advanced FeaturesUsing Call Breakthrough Remote OperationRemote Command List Quick Reference Chart One Year Limited Warranty WarrantyPage Page Page Thank YOU for Purchasing a Uniden Phone