Install Broadcast Message Router (BMR)
This manual assumes that each subnet is set up as specified in the CENTRACOM PC Software Installation User’s Guide.
The BMR allows messages to be relayed between subnets. In the CDM, the Broadcast Message Router Configuration (BMRC) allows system administrators to designate machines on their network.
Observe these installation and configuring notes before installing the BMR:
•The BMR is recommended to be installed on the same local LAN as the Inbound Event Display operator positions.
Warning: Running more than one BMR within a subnet will slow or crash that subnet.
•If there is more than one subnet, then exactly one BMR must be installed on each subnet. Installers must determine how many subnets are in the system and must identify an appropriate machine on each subnet for the BMR. However, loading the BMR onto the same machine as the CDM may slow the performance on that machine. In addition, a busy BMR on an Elite workstation may influence the performance. If a Dispatch User Interface is to be run on a BMR PC, the login on that PC must be the same as the account that PC's BMR is configured.
•Host names or IP addresses can be used but IP addresses are strongly recommended.
•BMR IP addresses or host names must be entered into all CDMs if more than one CDM is present for
| Gold Series™ Elite Inbound Event Display |