Motorola H9 manual Audio Tones Indicator Lights, Audio Tone Headset Status, Indicator Status

MAKING CALLS CONTINUED		MAKING CALLS CONTINUED
Function	Action	Function	Action
Toggle between two	Press and hold	Disable or enable the	Press and hold
active calls	the Call button until	indicator light	both Volume
	you hear a medium		buttons until you
	beep		hear a low beep
Join a 3-way call	Press and hold	AUDIO TONES
	both Volume buttons
	until you hear a
		The audio tones provide information about your
	medium beep
Put an active call on	Press and hold the	headset's status.
		Audio Tone	Headset Status
hold or resume a call	Call button until you
on hold	hear a medium beep	Single high tone when	Volume at minimum
Transfer a call from the	Tap the Call button	pressing Volume button	or maximum
phone to the headset		Five rapid high tones	Low battery
Transfer a call from the	Press and hold	repeated every 20 sec.
headset to the phone	the Call button until	No audio indications;	Out of range
	you hear a low beep	deteriorating quality
Mute or unmute a call	Tap both Volume	Ring tone	Incoming call
	buttons	Single very high	All calls ended
Note: Some features are phone/network dependent.		tone

AUDIO TONES CONTINUED			INDICATOR LIGHTS
Audio Tone	Headset Status		Indicator lights provide information about your
Single high tone	Tapping Call button		headset and charger base status.
	or both Volume			Charger Base
	buttons
			Indicator		Status
Single medium tone	Pressing Call button
			Charger Battery	On	Charging
	or both Volume
		( - )		Flashing Battery low
	buttons for 1-2 sec.
				Off	Charging complete
Single low tone	Pressing and holding
	Call button or both		Headset Battery	On	Charging
	Volume buttons for	( + )		Off	Charging complete
	greater than 2 secs.
Single high tone	Phone network not			Headset
repeated every 5 sec.	available
			Indicator		Status
Two ascending tones	Mute enabled
			Off		Power off
Two descending tones	Mute disabled
			On (steady)		Pairing mode
Four ascending tones	Headset powering
			10 rapid flashes		Pairing successful
	on
			Slow pulse		Connected (on a call)
Four descending tones	Headset powering
			Quick flash		Standby (not on call)
	off
			Note: After 5 minutes of inactivity, the light stops flashing to
			conserve power, but the headset remains in standby mode.