Setting up the telephone

Connecting the cords

Connect to jack

from distribution block

Connect to receiver

ATTENTION Before attempting to carry out any work on the telephone, ensure that the line cord is unplugged from the wall socket.

To remove any of the cords, squeeze the release latch on the plug and gently pull the plug from the socket.

Connect the handset cord to the jack labelled with the telephone icon and route the cord as shown.

If you are using a headset, route the cord along the channel in the base and connect the cord to the telephone jack that is marked with the headset icon.

Route the line cord through the stand and connect the cord to the telephone jack that is marked with the jack icon.

Attach the stand using either pair of slots; to raise the back of the telephone to its highest position, use these slots.

Once the above work is complete, plug

the line cord back into its wall socket.

Notice	These telephones now conform to the latest standards in relation to the
	positioning of Q and Z on the number keys. The Q appears on key number 7
	and the Z appears on key number 9.

Page 6

P0941600 Issue 01