Nortel Networks C4030 manual Installing and replacing batteries, Wall mounting the Charger

Page 5

	C40 30 Ha nd set		Stan da rd 1 .0 0

Wall mounting the Charger:		1.	Drill two holes into the wall, with
			vertical spacing of 65 mm, and insert
			the screws.
		2.	Plug the power cable into the
			charger.
		3.	Hang the charging unit on the
			screws.
		4.	Plug the power cable into the wall
			socket.
		5.	Place the telephone handset on the
			charger.

Note: Only use the charging unit supplied with the device.

Installing and replacing batteries

Read the following information before you handle the batteries.

•Heat or cold reduces the performance and service life of batteries.

A handset with hot or cold batteries can temporarily fail to operate, even if the batteries are fully charged. Keep battery temperature between 15 C and - 25C.

•Dispose of used batteries in accordance with local authority regulations. Do not dispose of batteries in fire.

Two rechargeable NIMH batteries (type AAA/RO3 1.2 V / 650 mAh) power the handset.

•Replace batteries with NTTQ00AA.

•Never use damaged, worn out, or non-rechargeable batteries.

•Only use stated battery type and recommended vendor models.

•The manufacturer disclaims responsibility if these recommendations are not followed!

7

Image 5

Contents Table of Contents C4 030 H and se t Stan d ard 1 Safety information Safety and initial setupSafety Precautions Environmental ProtectionInstallation Location Installing the HandsetInstalling the Charger Sensitive Electronic EnvironmentWall mounting the Charger Installing and replacing batteriesTo charge batteries To install or remove batteriesCharge Display Charge WarningTo discharge batteries Battery LifeDisplay screen C4030 Handset featuresHandset keys Icons Handset On/Off Using the C4030 handsetReceiving calls To receive callsTo correct an error Making a call in the Pre-Dial ModeTo make a call To hang upMute Ringing Volume AdjustmentActivating Handsfree To enable Silent mode Silent ModeTo set up an enquiry call Ringer typesTransferring a call Message Waiting Indicator for Call Pilot and Meridian MailIdentifying the callerr To transfer a callTime of Day Key LockTo lock the keypad To unlock the keypadAccess Meridian PBX features Standby mode Required to view the various menus Using Handset MenusSelecting a handset menu To choose a function from PressStoring telephone numbers Up to 100 entries Using keypad shortcutsPrivate Phonebook Key. Modifying a phonebook entry Character Table Deleting/Storing an Entry in Redial List Redial ListTo view the list of outgoing Calls Delete/Delete AllStore SettingsTo change the settings Function Shortcut Settings Default C4 030 H and se t Stan d ard 1 Handset settings Entering the Identification name AdministrationInitial Setup and Subscription To manually select a system Selecting a Dect systemProblem TroubleshootingAn error beep is heard during a call C4 030 H and se t Stan d ard 1