Nortel Networks NN10033-111 Assign, SimRing On switch To a line, Enabling SimRing on the DMS

Nortel Networks Confidential Configuration Management 31

Figure 6 SimRing configuration procedure flow

Enable	Assign	View
SimRing	SimRing	SimRing
on switch	to a line	status

Enabling SimRing on the DMS

Before adding SimRing to a line, make sure that table OFCENG is datafilled properly in order for SimRing to work. Sample datafill is shown below:

>TABLE OFCENG

MACHINES NOT IN SYNC - DMOS NOT ALLOWED JOURNAL FILE UNAVAILABLE

-DMOS NOT ALLOWED TABLE: OFCENG

>POS SIMRING_RES_CONTROL

SIMRING_RES_CONTROLY N

>POS SIMRING_CENTREX_CONTROL SIMRING_CENTREX_CONTROLY N

>POS NO_OF_CLONE_TIDS NO_OF_CLONE_TIDS 20

For detailed engineering information about configuring these OFCENG tuples correctly, please refer to the North American DMS-100 Translations Guide Volume 17 of 20 (Document Number:

297-8001-350).

Assigning SimRing on a DMS line

To assign SimRing to an existing line, use the EST (establish) command of SERVORD.

>SERVORD
SO:
>EST
SONUMBER:	NOW	0 8 16 PM
>$
GROUPTYPE:
>SIMRING

SIMRING_PILOT_LEN: >HOST 0 1 10 5

SIMRING_MEMBER_DN: >6215115

SIMRING_MEMBER_DN: >6215010

SIMRING_MEMBER_DN: >$

SIMR_STATE: INACT

Copyright © 2003, Nortel Networks MCP Interworking Basics