Configuring options
To pair the Bluetooth Headset with your phone:
1.Check with your administrator to ensure that Bluetooth is available for your use.
2.Restart your IP Phone 1140E using one of the following methods:
•If you are using an AC power adapter, unplug it, wait 10 seconds, and reinsert it.
•If you are using Power Over Ethernet (POE), unplug the LAN Ethernet cable, wait 10 seconds, and reinsert it.
3.
Note: If the Bluetooth Setup item appears dimmed, then your phone is not configured to support a Bluetooth headset; contact your system administrator.
4.Press the Enter key to activate Bluetooth.
A check mark is displayed to indicate that Bluetooth is activated. The message “BT Enabled” appears at the bottom of the display.
5.Put your Bluetooth headset in its pairing or search mode. The procedure for doing this can be different for each Bluetooth headset. Refer to the documentation that accompanied your headset, or contact the vendor.
For example, if you are using the GN Netcom GN 6210, do the following:
a.Turn the headset off by pressing and holding the telephone button for 3 - 4 seconds until a high to low tone is heard. The headset blue LED turns off.
b.Press and hold the telephone button for about 8 seconds until the blue LED flashes and then lights steadily.
6.Search for (pair) the headset:
a.Press the Right navigation key one or more times until the Search button is shown next to the Search Devices item.
b.Press the Enter key.
The message "Searching…." is displayed.
19