Gateway GW5-9210-8 manual Introduction, Programming the car for GW500, Installation Type

Page 1

INSTALL GUIDE

ice4Link Gateway 500 MOST

Introduction

Gateway 500 emulates a CD changer and uses CD changer controls to access offboard audio sources including iPod, USB devices and Dension Gateway accessories. If your car is not already equipped with a CD changer, it may be necessary to have the car programmed by your dealer in order to use the GW500 with it.

Programming the car for GW500

Audi

No programming required

BMW non iDrive-4

If original CD changer fitted and MP3 capability is available: no programming is required.

If original CD changer fitted and no MP3 capability is available:

a)Retrofit “KMP3” option with service computer

b)Used in non text capable BMW mode

If original CD changer not fitted or E60 M-ASK used: install GW500 and retrofit “IPOD” option with service computer

BMW with iDrive-4

If original CD changer fitted: no programming is required

If original CD changer not fitted: install an original BMW CD changer and retrofit “CD Changer” temporarily option with service computer

Mercedes

Generally no programming is required but in some cases (e.g. no device was connected onto the optical ring) it is needed to enable a CD changer with the service computer.

Porsche

Generally it is needed to enable a CD changer with the service computer but in rare cases the PCM accept the GW500 without this enabling process.

Saab 9-3

It is needed to enable a CD changer with the service computer using an original CD changer.

Package Content & Electrical Installation

Installation Type 1:

Vehicles supporting multiple CD changers and equipped with a CD changer

Audi A4/S4/RS4/A5/A6/S6/RS6/A8/Q7 with MMI-2 High (colour)

These vehicles allow selection of Gateway audio sources and the original CD changer through the existing car audio controls.

Set the DIP switches to the following position and install the Gateway

500 as illustrated below:

1a.

CDC

Remove the blue locking clip from the middle of the fibre optic housing.

1b.

Strain the hook carefully with a sharp tool, while pulling out the optical fibre from the housing.

1c.

Installation Type 2a:

Vehicles with an existing CD changer

These vehicles allow selection of Gateway audio sources and the original CD changer by switching the mode between CD Changer and Gateway mode.

Car side

CDC side

Audi (MMI-2 Basic Monochrome)

State of the art car integration

for media players, USB and

Bluetooth devices

GW5-9210-8

Car side

CDC side

1

 

4

2

 

Power

 

harness

 

Power harness:

 

-red wire

 

(+12V non switched)

 

-black (GND)

 

DIP switch

3

3.

Car side

Text capable BMW E87, E90, E91, E92, E93, E60/61, E63/E64, E65/E66 (03/2005-), E70 and Mini (non iDrive-4)

Non text capable BMW E65/E66 (-03/2005) (non iDrive-4)

BMW E90, E91, E92, E93 with iDrive-4

Mercedes (NTG1-, NTG2- Audio 20/50 and Comand)

Porsche (CDR 23/24 and PCM I/II/2.1) for longer CDC and car side cable use

FOA1PO1

CDR

PCM

Saab 9-3 (Rear CDC)

1

2

3

Image 1
Contents Installation Type Package Content & Electrical InstallationInstallation Type 2a IntroductionInstallation Type 3b Installation Type 3aInstallation Type 2b