Emerson MODEL EM1200 owner manual Remote Operation

REMOTE OPERATION

Remote Security Code

There is a three digit security code located on the bottom of your unit. Remember this number. You will need it to get your messages by remote when calling from a touch-tone phone. A space has been provided on the enclosed Quick Reference Card to write down your code.

Remote Turn On

If you forget to turn on your unit, you can call and remotely turn it on.

1.Call your phone number from a touch- tone phone.

2.The unit will answer after 9 to 10 rings, automatically turn on and play your outgoing message.

3.All subsequent calls will be answered.

Messages Playback

1.Call your phone number from a touch tone phone.

2.Your unit will answer and play the

outgoing announcement. Then you will hear a beep to signal that it is ready to record an incoming message.

3.Within ten seconds of the beep tone dial your 3 digit security code by pressing and holding each digit for 1 second.

4.Your unit will emit 4 short beep tones once correct code is detected and play- back all incoming messages. After the last message your unit will emit 4 short beep tones.

5.To repeat the remote message play- back, dial your 3 digit security code again within 10 seconds of the last 4 beep tones.

6.To end the remote message playback, hang up. All messages are automatically saved and your unit will reset itself to answer the next incoming call.

Remote Message Erase

1.After listening to your messages, the unit will emit 4 short beep tones, pause for 10 seconds and emit one beep tone.

2.Immediately after this single beep tone, dial your 3 digit security code, pressing and holding each digit for one full second.

3.Your unit will emit 4 short beep tones and disconnect the line. All messages will be automatically erased and your system will reset itself to answer the next incoming call

To Retrieve Messages When Recording Memory is Full

1.When maximum digital recording memory is reached, the unit will answer with 3 beep tones on the 10th ring.

2.Within 10 seconds after the beep tones, dial your 3 digit security code.

3.Your unit will emit 4 short beep tones once correct code is detected and play- back all incoming messages.

IMPORTANT

Remote messages retrieval will not work when calling in from a rotary or pushbutton pulse dialing phone unless a tone generator is used. Also, some tone dialing phones (cellular, PBX, etc.) Only output tones for a fraction of a second. If you experience difficulty with remote operation, try another phone, or use a separate tone generator.

11