Emerson MODEL EM1200 owner manual Troubleshooting Guide

Troubleshooting Guide (Cont.)

PROBLEM	POSSIBLE CAUSE	CORRECTIVE ACTION
No remote	Unit is in the "OFF" position	Check to verify if message counter is lit.
operation
	AC adaptor is disconnected	Reconnect AC adaptor into wall outlet or
	from wall outlet or back of	back of unit. Try connecting to a different
	unit	wall outlet.
	Power to electrical outlet	Check to see if electrical outlet is
	may be off	controlled by a light switch and power is on.
	Calling from a phone that is	Try calling your unit from a different
	not outputting tone dialing	(non-PABX, non-cellular) phone.
	(rotary, PABX, cellular).
	Telephone line is not	Connect telephone line into wall jack. Try
	connected to wall jack	connecting into a different telephone wall
		jack.
	Security code not entered	3 digit remote security code must be
	correctly	entered after your outgoing announcement
		Press and hold each digit for more than 1
		second.
	Remote security code being	Verify that the remote security code being
	used differs from the code	used matches the code on the bottom of
	on the bottom of unit	the unit.
After a power	A 9 volt battery has not	Install a fresh, alkaline 9 volt battery to
outage, outgoing	been installed or needs	maintain your outgoing announcement and
announcement	to be replaced	incoming messages in the event of a power
and incoming		failure.
messages are
lost
The machine	The outgoing message	Record a shorter outgoing message (less
beeps during the	you are recording is too	than 30 seconds).
recording of my	long
outgoing
messages
The machine is	The incoming message	Maximum recording time for incoming
cutting off	is too long	messages is 45 seconds.
incoming
messages

14