Cobra Electronics AN - 8630 - 25 manual Wall Mounting, Using Your Phone

1

Cobra®

Cob

WALL MOUNTING

On A Plate

Your Cobra Intenna is designed to be used with AT&T, GTE or any other wall-mounting plates that may be purchased from most local electronics or home repair stores.

1. Press the telephone cord into the slots under the base and wrap it around the cord storage area as shown.

2. Plug the phone connector into the telephone wall jack.

3. Plug the power adapter into the telephone base and a nearby AC power outlet.

4. To hang the phone base, simply align the holes on the bottom of the base with the studs on the wall plate and slide the base down until it locks into place.

1 5. To hang up handset, pull cradle hook to down position.

CRADLE

HOOK

Directly On The Wall

To install the base directly on any wall, you’ll need two screws and wall anchors (not included).

1. Drill two holes aligned vertically, one 31⁄4" higher than the other, and insert the wall anchors.

2. Drive the screws into the anchors until the head of each screw sticks out about 1⁄8" from the wall.

3. Plug the phone connector into the telephone wall jack.

4. Plug the power adapter into the telephone base and a nearby AC power outlet.

5. To hang the phone base, simply align the holes on the bottom of the base with the screws on the wall and slide the base down until it locks into place.

1 6. To hang up handset, pull cradle hook to down position.

CRADLE

HOOK

2

Cobra®

USING YOUR PHONE

Now that the handset batteries have charged overnight (at least 12 hours) your Cobra Intenna Cordless Phone is ready to use.

	To Answer A Call At The
2	Base
	When the phone rings, simply pick up
TALK	the handset from the base and the
	TALK button will automatically light.
	When you hang up the handset in the
	base, it disconnects.

To Place A Call At The Base

2Pick up the handset from the base,

TALK	then press and release the TALK button.
	When you hear the dial tone, place your
	call.

To Answer or Place A Call

Away From The Base

2The TALK button must be off (not lit)

TALK	when the handset is away from the
	base and not in use. Press and release
	the TALK button and, when your
	conversation is finished, press the TALK
	button again to disconnect. If you
	replace the handset in the base, the
	TALK button will disconnect
	automatically.
	Note: Some cordless telephones
	operate at frequencies that may cause
	interference to nearby TV’s and VCR’s.
	To minimize or prevent such
	interference, the base of the cordless
	telephone should not be placed near or
	on top of TV’s or VCR’s. If interference is
	experienced, moving the cordless
	telephone base further away from the
	TV or VCR will often reduce or eliminate
	the interference.

1

AN8630-25 NEED HELP? 1-773-889-3087