Getting Started
E
N G
WALL MOUNTING
INSTRUCTIONS
The phone unit may be mounted on a standard wall plate.The mounting bracket will mount on the telephone with the wide end of the bracket towards the bottom of the phone.
1.Plug one end of the flat telephone line cord into the jack marked TEL LINE located on the back of the telephone.
2.Insert the plug of the AC adapter into the jack marked DC 12V located on the back of the base unit.
3.Place the mounting bracket on the telephone with the wide end of the mounting bracket towards the bot- tom of the phone. With the back of the unit facing up insert the supplied mounting bracket’s upper tabs into the base’s upper tab slots. Depress the tabs located at the bottom of the mounting bracket and insert the tabs into the lower tab slots. Release the tabs to lock the mounting brack- et into place.
4.Pull up on handset knob and turn so that the knob extends out. This will hold the handset in the place when the phone is wall mounted.
5.Plug the flat telephone line cord into the wall plate jack, then align the mounting bracket’s key hole slots with the wall plate studs and slide the base of the phone down- ward to secure it on the wall.
6.Plug the AC adapter into an electrical outlet.
7.Set the TONE/PULSE switch located on the back of the base to correct dialing mode. Please check with your local telephone company if uncertain of the type of service.
8.Plug one end of the coiled hand- set cord into the bottom of the handset. Plug the other end of the handset into the modular jack marked HANDSET located on the left side of the phone. Place receiver in the cradle.
L
I
S
H
9