Wiring a mains plug
Should you have to replace the existing plug, use a standard (BS 1362) mains plug fitted with a 3 Amp fuse approved to BS 1362 and follow the wiring instructions below.
The wires in this mains lead are coloured in accordance with the following code:
BLUE - NEUTRAL
BROWN - LIVE
If the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, connect as follows:
The blue wire must be connected to the terminal marked with the letter N or the word ‘Black’.
The brown wire must be connected to the terminal marked with the letter L or the word ‘Red’.
No connection should be made to the Earth terminal marked with the letter E or coloured green or green and yellow, or marked by the safety earth symbol.
If any other plug or connection is used, a 3 Amp fuse must be fitted to either the plug of the adaptor or in the distribution board. If in doubt, contact a qualified electrician.
Safety Precautions
1Do not allow your clock radio to become damp or wet.
2Unplug from the mains before cleaning or moving.
3Do not loosen or remove any screws other than those specified in this guide.
4Do not use your Clock Telephone if the mains power cord or
5Do not use your Clock Telephone if it is damaged in any way or
if it does not function properly. Disconnect the mains plug from the wall socket and consult your dealer.
6Moisture condensation - If your Clock Telephone is moved from a cold to a warm enviroment, water in the air will condense on some parts of the appliance and may cause damage or malfunction if the equipment is used. Allow at least two hours for the Clock Telephone to acclimatise before switching it on.
13