Ameriphone JB-20 operating instructions Lift the handset and listen for a dial tone

Page 6

CHAPTER 4 INSTALLATION

Desk Mounting

1.Plug in the long phone cord.

2.Plug the handset cord into the telephone.

Fig.3 - Connections and installation

3.Lift the handset and listen for a dial tone.

4.Your DIALOGUE JB-20is ready to use.

Wall Mounting

1.Pull the handset hook out and reverse its position so that the hook points up.

Fig. 4 - Reversing the hook

2.Install the Base Plate by sliding the small tabs into the upper slots. Push on the bottom of the Base Plate until it snaps into place.

MANUAL

AUTO

Fig. 5 - Phone base installation for wall mounting

4

Image 6

Contents Operating Instructions Important Safety Instructions Contents Warranty Service Hold Lift the handset and listen for a dial tone Adjust the Ringer Tone selector to suit your hearing Adjust the Ringer volume control to suit your hearing Enter the phone number as you would normally dial it Lift the handset and press the Prog button Direct Audio Output Symptom Cause Corrective Action Chapter FCC Information Chapter Warranty Decibel Gain Helping people communicate easier