CHAPTER 5 (CONTINUED)
4.Changing Password for Remote Message Retrieval
In order to prevent any unauthorized access to your recorded messages, set up an Auto An- swer access password. Once created, it is set until you change it. If you forget your password, you can simply create a new one.
1. | Hold down |
| and press | 7 . | ||
| ||||||
2. | Press |
| repeatedly | until screen | ||
|
|
| appears. | |||
| CHANGE PASSWORD? Y/N | |||||
3. | Press Y to change the screen to | |||||
|
| . |
|
|
|
|
| PASSWORD:/ |
|
|
|
|
4.Type a password (up to 9 characters
long) PASSWORD:/MYPASS , for example.
Press to save your selection.
5.Hold down and press . to go back to normal TTY operation.
5.Turning Off Toll Saver and Selecting the Number of Rings for Auto Answer
DIALOGUE III and
1.To turn the
down and press 7 .
2.Press five times until
3. AUTO ANSWER RING (2) appears on the screen.
4.Press to change the number
of rings directly. Press to save.
5.Hold down and press to return to normal TTY operation.
6.Transmission Speeds
There are two accepted standard TTY message transmission speeds: U.S. Standard (45.5 Baud) and International Standard (50 Baud). In order for one TTY to talk to another, they both must be set at the same standard (speed). Your DIALOGUE TTY is preset to the U.S. Standard. To make or receive a TTY call outside of U.S., U.K., or Canada, you may have to change to the International Standard. Once changed, it will remain at that speed until changed again.
1. | Hold down |
| and press 7 . |
2. | Press |
| repeatedly until the |
| |||
| |||
| speed is displayed: (U.S. 45) SPEED |
3.If you need to set it to international speed, press the space bar. The screen
| will show (INTL. 50) SPEED |
| |||
4. | Everytime |
|
|
| the |
you press the |
| ||||
| transmission | speed changes. |
| ||
| Press | to select the speed |
| ||
| shown on the screen. |
| |||
5. | Hold down | and press |
| ||
| to return to normal TTY operation. |
|
7. Call Interrupt
DIALOGUE
this happens, " INTERRUPT " flashes on your
screen and the lamp flasher also blinks. You may continue to type or you can stop and wait for a response. If both parties are using DIA- LOGUE
by holding down | and | pressing I . |
If you're using a TTY other than DIALOGUE
DIALOGUE | |
user you must hit the | five to ten |
times until you get an acknowledgment. If you want to turn off the Interrupt feature, follow these steps:
1.Hold down and press 7 .
2.Press once and the screen reads INTERRUPT ON? Y/N .
3.Press N to turn off Interrupt feature.
4.Hold down and press to return to normal TTY operation.
9