AT&T 518-600-016 manual Dial #202, As an attendant position, and this cannot be changed

DESIGNATING ATTENDANT POSITIONS

With a BIS-34D Console

1Enter administration mode by sliding the T/P switch to P.

2Press Conference twice.

Lights flash nexto to Adm Tel, Adm Pool, Message, and Speaker.

3Press Message.

The green light goes on steady next to Message. All flashing lights go off.

4 Dial #202.

Two beeps sound.

5 Dial the appropriate number:

0 = Square

1 = Pooled with Button Access to line pools

2 = Pooled with Dial Access to line pools

3 = Pooled with Automatic Route Selection

4 = Behind switch

The message “System is Re-starting..." appears. When renumbering is complete, afier a short delay, the Lights jlash next to Adm Tel, Adm Pool, Message, and Speaker.

6Continue administration or leave administration mode by sliding the T/P switch to the center position.

Refer to the Master Planning Form for Feature Module 2 or Form 3a, System Form-Station Planning to determine which voice terminals should be attendant positions.

NOTE: The system is factory set with the station connected to jack 01 (default intercom number

10)as an attendant position, and this cannot be changed.

Keep in mind that there cannot be more than eight attendant positions; therefore, you can designate up to seven additional attendant positions. There can be only two attendant ports on each analog station module. Every fourth analog station port after port 01 (default intercom number 10) can be designated an attendant position. If

Administering a New System 3-23