Handset Settings Change Ring and KEY Tones | AT&T ID-282H specification

Caller ID is not displayed during a Call Waiting call

Handset does not ring

Keys activated while talking

Mute, intercom and speakerphone features do not work during a call

Low battery indicator displays, even

if recharged

Unable to register my new handset

•You must subscribe to Call Waiting Caller ID service through your local phone company for this feature to work. Contact your local phone company to confirm you have subscribed to for Call Waiting Caller ID service.

•While receiving the Call Waiting call, a second line was also off hook. The ID-282H cannot receive Call Waiting ID data when a second line is also off hook

•Ring Volume is set to ‘OFF’ (see the section in the ID-2820 manual titled

HANDSET SETTINGS - CHANGE RING AND KEY TONES )

•Activate the Smart Key Lock feature

(see the section in the ID-2820 manual titled

HANDSET SPECIAL FEATURES )

•Make sure that your ear is touching the top section of the handset (receiver) when you are talking.

•Check if manual Key Lock or Smart Key Lock is engaged. (See the section in the ID-2820 manual titled HANDSET SPECIAL FEATURES )

•Battery pack may need to be replaced. Do not mix new and old battery packs or battery packs of different types. Replace battery pack with the same or equivalent type recommended by the manufacturer. [NIMH 650mAh 3.6V(AAA) battery pack].

•A maximum of 4 handsets can be registered at one time. De-register a handset and try again.

•Make sure you select a base number that has not been assigned