AT&T Single Line Business Telephone warranty For All Telephones, To Remove Your Telephone

Page 5

AT&T

2.Plug one end of the coiled handset cord into the jack in the handset. Push the plug in until it clicks.

3.Plug the other end of the cord into the jack in the bottom of the wall base. Push the plug in until it clicks.

4.Adjust the ringer volume switch on the upper right side of the telephone to the desired setting.

For All Telephones

Place the number card on your telephone following the instructions on the back of the number card label.

RINGER

VOLUME

CONTROL

RIVETS

JACK

COILED HANDSET

WALLCORD JACK

PHONE

PLUG

COILED HANDSET CORD

HANDSET

JACK

Figure 4. Wall Telephone Installation

To Remove Your Telephone

1.To disconnect or remove your telephone reverse the installation procedures. To remove any modular plug, squeeze the clip of the plug and pull it out of the jack.

2.To disconnect a wall set, slide the set up to lift it off the rivets and pull it away from the wall.

Image 5
Contents AT&T Issue 3APRILModular Outlet Requirement Package ContentIntroduction To Install Your Desk Or Trimline Telephone InstallationTo Install Your Wall Telephone To Remove Your Telephone For All TelephonesApparatus code is stamped on the bottom of the set WarrantyApparatus Standard Network Code Interface Jacks Page Hearing Aid Compatibility