In compliance with the rules, you should be aware of the following:
1.Connection of this equipment to the telephone network must be through one of the standard network interface jacks listed above. These may be ordered from the local telephone company or through AT&T Information Systems as your authorized agent.
2.Customers connecting equipment to the telephone network shall, upon request of the local telephone company, provide the following information:
●The telephone number assigned to the line used with this telephone.
●The Registration Number and the Ringer Equivalence Number (REN) from the Registration label on the bottom of the telephone.
Note: This equipment is registered to be used on telephone lines with “A” type ringing frequencies. However, some telephone companies use a variety of other ringing frequencies, e.g., “B”, “C”. As a result, this telephone may or may not ring properly when connected to a telephone line that provides other than “A” type ringing. Consult your AT&T Information Systems representative for advice.
3.Notify the local telephone company when this equipment is permanently disconnected from the line.
4.If trouble is experienced, the telephone set should be unplugged from the network interface to determine if the telephone set or the telephone line is the trouble source. If your telephone set is determined to be malfunctioning, it should not be reconnected until repairs are made.
5.Repairs to this equipment, other than routine repairs, can be made only by AT&T Technologies or its authorized agents.
6.If a telephone set causes harm to the telephone network, the local telephone