TABLE/DESK INSTALLATION
1.Set Dial Mode switch This product comes set in the tone (TT) mode. Make sure you choose the correct dialing method (TT/DP); touch tone dialing will not work if you have dial pulse service.
2.Connect line cord to telephone and wall jack Plug one end of the line cord into the jack on the telephone and the other end of the line cord into a modular wall jack. Make sure it snaps firmly into place.
3.Connect handset to telephone base
Plug one end of the coiled handset cord into the jack at the side of the telephone base and plug the other end into the handset. Then hang up.
4.Check for dial tone
Lift the handset and listen for a dial tone. If you can't hear a dial tone, refer to “In Case of Difficulty” and try to correct the problem.
TO DISCONNECT the line and handset cords, squeeze the clip on the modular plug and pull it out of the jack.
Dial Mode Switch
2