Telephone’s Analogue Adapter – UTStarcom | pag.5 |
ACCESS TO THE ADAPTER
When you finished the connections, you can proceed with the
Before proceeding with the ATA configuration it is necessary to verify if in your router the DHCP service is working, (this means that in your LAN are used IP addresses in a dynamic way), or if the DHCP service is not working, (this means that in your LAN are used IP addresses in a static way).
Based on what mentioned above, please proceed with the suitable instructions that follow.
Access to ATA when the DHCP service is working
1.verify that the LAN port of your PC is configured in order to obtain an IP address automatically.
Click on “Start \ Settings\ Network connections“, double click on “Local area connections (LAN)” .
In the new window click on “Properties” and then double click on “Internet Protocol (TCP/IP)”.
Verify that the option “Obtain an IP address automatically” is activated or modify the setting and press “OK” .
At the end, you can close all the opened windows.
2.verify which IP address has been assigned to your
Access your router in configuration mode and in the status information about the “LAN” or on “DHCP client” check which IP address has been assigned to your
3.start your Web Browser (i.e. Internet Explorer), insert the IP address of your
4.It will appear the window prompt for “Network Password” in which you have to insert “supervisor” as User name and your personal Password, received from Eutelia, as Password (if you didn’t receive any indication, use the “Eutelia” password).
Attention! The confidentiality of these data is necessary in order to guarantee that the equipment configuration is accessible only by you. We suggest to proceed with the configuration password change and to write down the new one.
5.After few moments, the “System Status” of your
IMPORTANT: the changes made are not going to be effective before “Save” and “Reboot” of the ATA, as indicate in the following pages.