Your KONEXX Office Konnector must have AC power to operate in Data Mode.
♦Use only the AC adapter supplied with your KONEXX Office Konnector. Do not use an adapter for a different device.
______________________________
Telephone Level switch__________
Make sure the Telephone Level switch is set properly. Otherwise, you will hear buzzing or squelching feedback through the modem speaker when the modem is
____________________________ _
Tone dialing____________________
Make sure your modem, fax/modem, or fax machine is configured for Tone (DTMF) dialing. Your KONEXX Office Konnector will not work with pulse (rotary) dialing.
The manual that came with your modem, fax/modem, or fax machine should describe this procedure.
______________________________
V.90 Connections
The KONEXX Office Konnector provides a data communications interface between your modem and any PBX or
To obtain 33,600 bps connections, the remote modem or fax/modem must support V.34bis, and the
______________________________
Speakerphones_________________
Make sure the telephone handset is removed from the cradle until you finish exchanging data. Hang up your modem or fax/modem to reactivate the handset.
If the telephone has a speaker, the speaker must be turned off. Speakerphone operation disables the telephone handset jack that your KONEXX Office Konnector uses to transmit and receive data. The handset must be removed from its cradle.
______________________________
Princess and Trimline telephones__
Your KONEXX Office Konnector will not operate with "Princess" or "Trimline" telephones, which have the keypad in the handset. The electronics with which the KONEXX Office Konnector interacts are not accessible in these telephones.
______________________________
Hanging up the modem__________
Your KONEXX Office Konnector disconnects the telephone handset when your modem or fax/modem is
You can either use the
If you are using contact management software, you may need to push a key on the computer keyboard to disconnect the modem or fax/modem after the number is dialed.
______________________________
"No Dial Tone" error message____
If you receive a "No Dial Tone" error message, include the Hayes command ATX1 or ATX3 in your modem Dial command. These commands tell your modem or fax/modem to dial without first listening for a dial tone.