Valcom V-9908 dimensions Programming the Message Panel, System Troubleshooting

Page 3

Figure 1 shows microphone, message activate and fault indication control locations.

Figure 2 shows remote message activate terminal connections, output connections, programming and power connections located on the back of the message panel.

Figure 3 shows a typical connecting arrangement and other feature connections for a Fully Supervised system, including speaker wire run supervision. Fully supervised systems require a Valcom V-9999 End of Line terminator (not included). Refer to Figure 3 to connect the message active contact and remote activation of the messages. Using a RJ-45 connector, connect speaker audio (Tip and Ring) and speaker power to board mounted connector as shown on connecting diagram. (A remote mounted connecting block will be required to access these connections.) Referring to Figure 3, connect 24VDC as indicated.

When installed without full wire run supervision, a Valcom V-1096 Audio Interface is required to be installed inline on the audio output between the V-9908 Message Panel and the first connected device (page control or speaker – refer to page 5 for details)

Programming the Message Panel

Refer to the programming guide included with the message panel documentation.

System Troubleshooting

There are 4 LED’s located on the PC board for system troubleshooting. They are:

LED D9 - Mic. Switch Fault (ON = fault detected)

LED D10 - DC Fault (low battery or internal monitoring System fault) (ON = fault detected)

LED D11 - Audio loop back fault (ON = Fault in Mic. audio or 30Hz amplifier loop back)

LED D12 - Flash Memory Error (ON = Checksum failed)

TECHNICAL ASSISTANCE

When trouble is reported, verify the unit is turned on and there are no broken connections leading to the unit.

Assistance in troubleshooting is available from the factory. When calling, you should have a VOM and a test set and call from the job site. Call (540) 563-2000 and press 1 for Technical Support, or visit our website at http://www.valcom.com.

Valcom equipment is not field repairable. Valcom maintains service facilities in Roanoke, VA. Should repairs be necessary, attach a tag to the unit clearly stating company name, address, phone number, contact person, and the nature of the problem.

Send the unit to:

Valcom, Inc.

Repair and Return Dept.

5614 Hollins Road

Roanoke, VA 24019-5056

VALCOM LIMITED WARRANTY

Valcom, Inc. warrants its products only to the original purchaser, for its own use, to be free from defects in materials and workmanship under conditions of normal use and service for a period of one year from the date of shipment. This Limited Warranty obligation shall be limited to the replacement, repair or refund of any such defective device within the warranty period, provided that:

1.inspection by Valcom, Inc. indicates the validity of the claim;

2.the defect is not the result of damage, misuse or negligence after the original shipment;

3.the product has not been altered in any way or repaired by others and that factory sealed units are unopened (a service charge plus parts and labor will be applied to units defaced or physically damaged);

4.freight charges for the return of products to Valcom are prepaid;

5.all units 'out of warranty' are subject to a service charge. The service charge will cover minor repairs (major repairs will be subject to additional charges for parts and labor).

This Limited Warranty is in lieu of and excludes all other warranties, expressed or implied and in no event shall Valcom, Inc. be liable for any anticipated profits, consequential damages, loss of time or other losses incurred by the buyer in connection with the purchase, operation, maintenance, installation, removal or use of the product. The maximum liability of Valcom under this warranty is limited to the purchase price of the specific Product covered by the warranty.

Disclaimer. Except for the Limited Warranty provided herein, the product is provided “as-is” without any warranty of any kind whatsoever including, without limitation, any WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR NON-INFRINGEMENT.

This warranty specifically excludes damage incurred in shipment. In the event a product is received in damaged condition, the carrier should be notified immediately. Claims for such damage should be filed with the carrier involved in accordance with the F.O.B. point.

Headquarters:

Valcom, Inc.

5614 Hollins Road Roanoke, VA 24019-5056

Phone: (540) 563-2000 FAX: (540) 362-9800

3

947980

Image 3
Contents Introduction FeaturesDimensions SpecificationsSystem Operation InstallationIndicators Figure System Fault MonitoringSystem Troubleshooting Programming the Message PanelValcom, Inc Repair and Return Dept Hollins Road Roanoke, VA Contact Closure Inputs Serial Programming Input9 V Alkaline BatteryTypical Connections Fully Supervised System Preprogrammed Messages included