Connecting the Units | <ENGLISH> | Installation | <ENGLISH> |
7When using a Subwoofer without using the optional amplifier
This product
Front output
Subwoofer output |
|
Antenna jack | Fuse |
Rear output
16 cm
Jack for theWired Remote Control Please see the Instruction Manual for the Wired Remote Control (sold separately).
Note:
• Before finally installing the unit, connect the |
wiring temporarily, making sure it is all connected |
up properly, and the unit and the system work |
properly. |
• Use only the parts included with the unit to ensure |
proper installation. The use of unauthorized parts |
can cause malfunctions. |
• Consult with your nearest dealer if installation |
requires the drilling of holes or other modifications |
of the vehicle. |
• Install the unit where it does not get in the driver’s |
way and cannot injure the passenger if there is a |
sudden stop, like an emergency stop. |
• The semiconductor laser will be damaged if it |
•If installation angle exceeds 60° from horizontal, the unit might not give its optimum performance. (Fig. 4)
60°
Removing the unit (Fig. 6) (Fig. 7)
Frame
Insert the release pin into the hole in the bottom of the frame and pull out to remove the frame.
(When reattaching the frame, point the side with a groove downwards and attach it.)
(sold separately) |
Blue/white
overheats, so don’t install the unit anywhere hot |
— for instance, near a heater outlet. |
Fig. 4
Fig. 6
Insert the supplied extraction keys into the unit, as shown in the figure,
Yellow/black
If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. If not, keep the Audio Mute lead free of any connections.
Yellow
To system control terminal of the power amp or 
DIN Front/Rear-mount
This unit can be properly installed either from “Front” (conventional DIN
DIN Front-mount
until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out.
To terminal always supplied with power regardless of ignition switch position.
Red
To electric terminal controlled by ignition switch (12 V DC) ON/OFF.
Orange/white
To lighting switch terminal.
Black (ground)
To vehicle (metal) body.
+ | White | Gray | + |
|
| ||
Front speaker |
|
|
|
≠ | White/black | Gray/black | ≠ |
Left |
| ||
|
|
| |
+ | Green | Violet | + |
|
| ||
Subwoofer |
|
|
|
≠ | Green/black | Violet/black | ≠ |
|
|
Front speaker
Right
Subwoofer
Installation with the rubber bush (Fig. 5)
Dashboard
182
53
Holder
After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)
Rubber bush
Screw
Fig. 7
Note:
Change the initial setting of this unit (refer to the Operation
Manual). The subwoofer output of this unit is monaural.
Fig. 5
Fig. 3