Indicators, Connect Function, Belt Clip

Connect Function

The menu selection CONNECT is intended for use by service personnel only. When selected, an alternating pattern of CC CC is displayed. To exit this screen, press any button twice and the pager restarts.

Message and Pager Indicators

Your pager has several indicators to inform you of the status of your messages and your pager.

Duplicate Message

When a new message is received that is identical to one already stored, the older message is overwritten by the new one. DUPLICATE is displayed before the new message and new time stamp.

Errored Data

When a message is received that might contain errors, the characters likely to be in error ﬂash when the message is read.

Alarm

The alarm icon l is displayed when the alarm is set and ﬂashes during the alarm alert.

Belt Clip

Your pager has a removable belt clip. To remove and replace the belt clip, follow the instructions below.

INDICATORS		INDICATORS

Memory Full

When the pager memory is full, for example, all message locations are occupied, MEM FULL is displayed on the Standby screen until a button is pressed. When this occurs, delete your old unwanted messages to make room for newer messages. MEM FULL is also displayed if you try to move a message into the message folder when there is not enough storage space left.

Note: If you don’t delete any old messages, the pager automatically deletes the oldest read message to make room for the new message.

Low Battery

When the voltage of the pager’s battery drops below a certain level, b is displayed on all screens, even when the pager is off. The low-battery condition is displayed until the battery is replaced.

Note: Check your pager’s clock time after replacing the battery.

Cleaning Your Pager

To clean smudges and grime from the exterior of your pager, use a soft, non-abrasive cloth moistened in a mild soap and water solution. Use a second cloth moistened in clean water to wipe the surface clean. Do not

Removing the Belt Clip

➊Insert the pointed end of a non-metallic item (such as a pen cap) into the top end of the belt clip as shown in the illustration.

➋Push upward on the tab and slide the belt clip forward to separate it from the pager.

Lift tab up to release belt clip

immerse in water. Do not use alcohol or other cleaning solutions.

Replacing the Belt Clip

➊Align the belt clip with belt clip holder.

➋Slide the belt clip into the holder until it snaps back into place.