Polycom Installing and Starting Up, Metal Bracket, Back Expansion Module, Back VVX Phone

Installing and Starting Up

1Connect the base stand to your Expansion Module at the same angle as your phone’s stand.

2Position the phone and Expansion Module next to each other on a flat, level surface. Position them as closely together as you can. Then, locate the holes for the thumb screws; the holes are located between the top-most and middle stand slot.

	Back of
	VVX Phone
	Holes for
	thumb screws.
	Position holes in
Back of	metal bracket
	over these holes.
Expansion
Module	Middle
	stand slot

3Hold the metal bracket so that the four tabs face away from you, and the arrow on the back of the bracket points up. Position the holes in the metal bracket over the thumb screw holes. The four tabs on the bracket fit in the top-most and middle stand slots. Insert the thumb screws in the holes, and finger tighten.

Metal

Bracket

4Turn the phone and Expansion Module upside down on the table. Insert the Cable Connector between the AUX port on the phone, and the AUX 1 port on the Expansion Module. Thread the cable through the Cable Grooves on the Expansion Module and phone. If the phone is connected to the network, the Expansion Module will automatically power on and start up.

Back of

Expansion

Module

48V

AUX 2 AUX 1

HEADSET LAN PC HANDSET

Back of

VVX Phone

AUX

5To connect another Expansion Module, attach another Cable Connector between the AUX 2 port on the first Expansion Module and the AUX 1 port on the second Expansion Module. You can connect a maximum of three Expansion Modules to one phone, as shown next.