USING THE SOUNDSTATION PREMIER WITH TWO
EXTENDED HYPERCARDIOID MICROPHONES
To place a call:
Press ON/OFF to turn the SoundStation Premier console on, and dial the number.
USING THE SOUNDSTATION PREMIER
To program and retrieve the conference phone’s phone number
When power is first applied to the phone, the display will read ENTER PHONE #. Type in the phone number with area code use the * key to enter a space. When finished, press the FLASH key.
To retrieve the phone number at any time during a phone call, press SHIFT, then press the FLASH key. The phone number will be displayed for 10 seconds, then return to its previous mode.
To adjust the phone’s ringer volume
When the phone is off, press SHIFT, then press 
VOL or VOL 
. There are four options: OFF, LOW, MID, HIGH, and the levels will be heard after each key press. After 5 seconds, the phone will return to its previous mode.
To use tone dialing or pulse dialing
When the phone is off, press SHIFT, then press REDIAL. The display will read either TONE DIALING, or if REDIAL is depressed again, PULSE DIALING. The display will return to your phone number after 5 seconds.
NOTE: Toggle between
TONE or PULSE by
depressing the REDIAL key only.
To access digital services, such as voice mail, where only pulse dialing is available, SoundStation Premier can provide temporary tone dialing. When the phone is ON, press SHIFT, then press REDIAL. The display must read TONE DIALING for this feature to be activated. Once the phone is hung up, dialing will revert to its previous mode.
NOTE: Changing the type of dialing used when a call is in
progress in only temporary.
To place or answer a phone call
Press ON/OFF to turn the unit on and dial the number. The display will go blank, then show each number as it is being dialed.
NOTE: If caller ID is not available, there will be no time of day clock.
For incoming calls and when caller identification is activated, the display will show the caller’s phone number. The time of day clock will be initiated once a call is made to the phone.
Once the call is connected, a clock will appear on the display showing how long the call has been in progress.
To adjust tone volume and speaker volume
When the phone is on and dial tone is heard, adjustment of the dial tone volume can be made by pressing VOL or VOL .
NOTE: There are 32 volume levels for both dial tone and speaker volume.
NOTE: The volume levels for dial tone and speaker are stored independently in the phone’s memory.
The display will show: TONE VOL IIIII II. After 5 seconds, the display will revert to its previous mode.
Once a call is connected, the speaker volume can be made louder by pressing VOL 
or softer by pressing 
VOL. The display will show SPKR VOL IIIII II. After 5 seconds, the display will revert to its previous mode.
SoundStation Premier Full Duplex Conference Phone and Wireless Microphone User’s Guide | SoundStation Premier Full Duplex Conference Phone and Wireless Microphone User’s Guide |