2 Attach the stands to the speakers.
Ensure the stand is fastened on straight by gradually tightening the top and bottom screws alternately until fully tightened.
Long screws
Pipe
Speaker
You can also attach to the lower rear of the speaker.
The height of the speaker can be changed when attaching the stand to the upper rear or lower rear of the speaker.
3 Connect the speaker cables.
Rear of the speaker
Twist off the vinyl ends of the speaker cables.
_: Copper
`: Silver
Push!
Press the speaker cable into the groove.
If there is any excess speaker cable, thread the speaker cable into the opening near the top of the pipe while pulling the speaker cable from the bottom of the base.
4 Secure the speaker cables to the bases.
Press the speaker cable into the base cover groove as far
as possible.
Rear side of base
Cable 
Groove
∫Preventing the speakers from falling over ([HT840] [HT880])
Preparation
Attach screw eyes (not included) to secure the speakers to the wall (➜ diagram below).
≥You will need to obtain the appropriate screw eyes to match the walls or pillars to which they are going to be fastened.
≥Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that may not have strong enough support. Improper attachment may result in damage to the wall or speakers.
1Thread the string (not included) through the slot on the rear of the speaker to prevent it from falling over.
2Loop the string through the screw eye and tie tightly.
Screw eye (not included) |
|
String (not included) | Wall |
|
Approx. 150 mm
Rear of the speaker
Speaker assembly
RQT7978
5