RTS SSA-424A manual Call Signal Option Card Installation

Call Signal Option Card

Installation

Use these instructions to install a Call Signal Option Card in a SSA-424A that was originally ordered without it.

1.Disassemble the SSA-424A as previously described.

2.Assemble the standoffs to the circuit board using the supplied screws and lock-washers.

3.Connect the supplied power cable from J8 on the option card to J303 on the main board of the SSA-424A.

4.Insert the connectors on the option card into the connectors on the main board.

5.Use the remaining screws and lock-washers to secure the standoffs to the main board.

6.Reassemble the SSA-424A.

FIGURE 3. The Call Signal Option Card after installation in the SSA-424A.

16