Radio Shack 43-124 manual Using ac adaptor, Using rechargeable batteries, Battery Notes

Page 1

VOX

For hands-free communication, press

using ac adaptor

43-124

VOX until the VOX level indicator lights

 

 

 

900Mhz Wireless Intercoms

to communicate through the intercom

hands-free. Repeatedly press VOX

 

 

 

to set the sensitivity level, from low,

 

 

 

medium, to high.

Thank you for purchasing the 900Mhz Wireless Intercoms

VOX function turns off when VOX level

indicator turns off.

from RadioShack. With a line of site of up to 200 feet,

 

In VOX mode, there is a short

 

you can use your new intercoms in large areas. You can

 

NOTE

delay between when you

also connect auxillary audio sources and weather radio

 

start talking and intercom

(neither included).

 

 

 

 

 

transmission.

 

 

 

 

 

 

 

RECEIVE BUSY

 

 

 

 

 

 

 

 

 

Lights when

 

 

 

 

 

you receive a

 

 

 

 

 

voice message

 

 

 

 

 

or when you

 

 

 

 

 

monitor a locked

 

 

 

 

 

intercom. Flashes

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

when channel is

 

 

 

 

 

in use.

 

 

 

 

 

 

 

 

 

 

 

 

TALK

Hold down and speak into the MIC, release to listen when VOX mode turns off.

MIC

ON/OFF VOLUME

(Right Side) Turn VOLUME until it clicks to turn on, the POWER/BATT LOW indicator lights, then adjust VOLUME to a comfortable listening level.

Insert the AC adapter into the DC 9V jack and a standard AC outlet to power your intercom and/or charge batteries.

 

• You must use a Class 2 power source that

 

 

supplies regulated 9V DC and delivers at

 

 

NOTES

 

least 350 mA. Its center tip must be set to

 

positive and its plug must fit the intercom’s

 

 

DC 9V jack. Using an adapter that does not

 

 

meet these specifications could damage the

 

 

intercoms or the adapter.

 

• The correct orientation for this power unit is

 

 

in a vertical or floor mount position.

LOCK

To monitor continuously, press until the TRANSMIT indicator flashes. Press TALK to unlock.

When an intercom is in the LOCK mode,

NOTE it cannot receive voice messages or call tones from the other intercom.

CALL

Press to sound a tone (or call) on another intercom for about three seconds.

using rechargeable batteries

To charge rechargeable batteries (not included), slide the RECHARGE ON/OFF switch to ON, install batteries, plug in the AC adapter, then turn on the intercom. Complete charging takes about 12 to 14 hours. Average charging time varies with different battery capacity.

NiMH (1500 mAH) batteries charge in about 12 hours.

NiCd (700 mAH) batteries charge in about 4 hours.

AC adapter

Battery Notes:

Use only fresh batteries of the required size and recommended type.

Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities.

If you do not plan to use the intercoms with batteries for a week or more, remove the batteries. Batteries can leak chemicals that can destroy electronic parts.

Dispose of old batteries promptly and properly. Do not burn or bury them.

Always connect the AC adapters to the intercoms before connecting them to AC power.

Do not attempt to charge alkaline batteries and never install non-rechargeable batteries when RECHARGE ON/OFF is set to ON. Nonrechargeable batteries can get hot or explode if you try to charge them.

WARNING

You must slide the RECHARGE ON/OFF

switch to ON before charging rechargeable

 

 

batteries.

what’s included

Wireless Intercoms (2)

AC Adapters (2)

User’s Guide

Please read this user’s guide before

installing, setting up and using your new product

www.radioshack.com

©2007 RadioShack Corporation.

AO0286AAC1

All rights reserved. RadioShack and

43-124

RadioShack.com are trademarks

07A07

used by RadioShack Corporation.

Printed in China

 

43-124.indd 1

setting the channel and sub tone

By default your two intercoms are on the same channel, but you can change your intercom channels for your system. Or, if you receive interference on a channel you selected, set each intercom to one of eight different sub tones. Complete the following to change the intercoms channel or sub tone:

1.Open the battery compartment of the intercom and set the SUB or CH switches.

2.Use a pointed object to set the first three switches

(labeled SUB TONE) inside the battery compartment you want to use.

SUB TONE

CH

RECHARGE ON/OFF

07/25/2007 11:34:13

Image 1
Contents Using rechargeable batteries Using ac adaptorSetting the channel and sub tone Battery NotesLimited 90-Day Warranty SpecificationsRF Emissions Information
Related manuals
Manual 1 pages 30.01 Kb